Wire mesh Conveyor / Model 190 RBW

Wire Mesh Conveyor (Model 190 RBW) is used for drying operations, painting, wet or oily products, ovens or freezers.

Specs and Features

Belt - 12", 18", 24" and 36" wide, 1/2"x1" flat wire belt.
Bed - 1.9" diameter rollers mounted on 6" centers in 6-1/2" deep x 12 gauge powder painted formed channel, bolted together with splice plates and supports.
Drive Sprockets - 6" pitch diameter cast iron sprockets machined for 1-3/16" diameter shaft.
Tail Pulley - 4" diameter with 4" pitch diameter cast iron sprockets on each end of pulley, 1-3/16" diameter shaft.
Snub Roller - Adjustable 2" diameter roller located directly behind drive sprockets and tail sprockets.
Return Idlers - 1.9" diameter, adjustable, on 10'0" centers.
Take-Up - 6" long screws located at tail pulley to tighten belt.
Bearings - Sealed and pre-lubricated with heavy duty housing.
Floor Supports - Adjustable 31" to 45" from floor to top of belt.  One support supplied at each end of conveyor and at each bed joint.
Speed Reducer - C-Face mounted heavy duty worm gear reducer.
Motor - 1/2 HP 230/460-3-60 TE motor.
Belt Speed - 60 FPM constant.
Capacity - Maximum load per linear foot of conveyor - 75 pounds.  Not to exceed Load Capacity Chart.