Incline Belt Conveyor

Inclined Slider Bed Conveyor (Model FTC) is used for transporting cartons between levels or floors.

Specs and Features

• Booster conveyor for gravity flow systems
• Transporting between floors
• Center drive

Belt - 14", 18", 24", 30" and 36"wide rough-top belt.
Bed - 20", 24", 30", 30", 36" and 42" wide 12 gauge powder painted formed steel slider bed. Bed is 6-1/2" deep x 6 feet, 8 feet or 10 feet long spliced together with splice plates.
Under-Trussed Bed - Extra reinforcement to prevent sag in longer bed sections in addition to reinforcing angles, 24 feet and longer.
Double Nose-Over - Two 16" long adjustable bed sections provide a two step transition from incline to horizontal with 15° to 35° adjustment.
Tail Pulley - 4" diameter, crowned with 1-3/16" diameter shaft through 30" wide belt. 6" diameter tail pulley with 1-7/16" diameter shaft turned down on ends for wider than 30" belt.
Drive Pulley - 8" diameter crowned and lagged. 1-7/16" diameter.
Snub Roller - 2-1/2" diameter at drive pulley and 2" diameter at tail pulley.
Return Idlers -1.9" diameter, adjustable.
Take-Up - Located in center drive assembly, provides 24" of belt take-up.
Pop-Out Roller - Free floating, 1-3/8" diameter rollers located at tail pulleys with gravity connector rods.  Will lift out if anything is caught between pulleys and rollers.
Floor Supports - Adjustable stands to give 31" to 45" height at each end;with knee braces.
Bearings - Sealed prelubricated with cast iron housings.
Speed Reducer - C-Face mounted heavy duty worm gear reducer.
Motor - 3/4 HP 230/460-3-60 TE motor.
Belt Speed - 60 FPM constant.
Capacity - 100 lbs. per foot maximum. Not to exceed Load Capacity Chart.