Belt Driven Live Roller Conveyor

Belt driven Live Roller Conveyor (Model 130 CAP RBW) is used accumulating light boxes, bins, totes or baskets. This conveyor is a very economical way to achieve a minimum back pressure system.

Specs and Features

Driving Belt - 4" wide Black PVC 120 belt.
Bed - Roller bed width between frames, 10", 13", 16" and 22".  5-1⁄2" x 1-1⁄2" x 12 gauge powder painted formed steel channel frame, bolted together with butt couplings and floor supports.
Tread Rollers - 1-3⁄8" diameter x 18 gauge galvanized tread rollers with 5⁄16" hex shafts on 1-1⁄2" and 3" centers. Safety pop-out design prevents damage to product or harm to personnel if caught between belt and tread rollers.
Pressure Rollers - 1-3⁄8" diameter x 18 gauge galvanized pressure rollers with 5⁄16" hex shafts on 6" centers.
X-Bracing - Frame Squaring device supplied on conveyors 40 feet and longer on every other bed section. X-bracing insures good product and belt tracking.
Tail Pulley - 4" diameter crowned with 13⁄16" shaft.
Drive Pulley - 4" diameter crowned and fully lagged, with 1-3⁄16" diameter shaft.  Located at in feed end of conveyor.
Snub Roller - 2" diameter adjustable, located directly behind drive and tail pulley.
Return Idler - 1.9" diameter, adjustable, on 10'0" centers.
Floor Supports - 30" to 44" adjustable from floor to top of rollers.  One support supplied at each end of conveyor and at each bed joint.
Take-Up - Located at discharge end of conveyor, provides 12" of belt take-up.
Bearings - Sealed, pre-lubricated with cast iron housings.
Speed Reducer - Heavy duty worm gear reducer.
Motor - 1⁄2 HP 230/460-3-60 TE motor.
Belt Speed - 60 FPM constant.
Capacity - 100 pounds per foot.  Not to exceed Load Capacity Chart.